Guide de préparation
Toyota Supra A70 (Mk3)
Moteur: 7M-GTE (3.0GT Turbo) / 1JZ-GTE twin turbo (2.5GT Twin Turbo)
The 7M-GTE has a strong iron block but a well-known head-gasket weak point. Fixing that properly with studs and a quality gasket is the entry ticket to any power. The JDM 2.5GT Twin Turbo uses the 1JZ-GTE with ceramic CT12A twins. Both come with the strong R154 5MT in manual form.
Ce guide est en anglais pour l’instant.

Photo : Rudolf Stricker · CC BY-SA 3.0 · Wikimedia Commons
- Étape 0 · BaseStock (~230 hp 7M / ~280 PS 1JZ)Head gasket and studs done before any boost.~$2,500–5,000 CAD
- Étape 1 · Rue~260–300 whp (7M) / ~260–300 whp (1JZ, near 1 bar)Exhaust, boost control and mild boost.~$2,000–4,500 CAD
- Étape 2 · Sportive / Piste~350–450 whpStandalone ECU, fuel and a CT26 hybrid or small single.~$6,000–12,000 CAD
- Étape 3 · Préparation complète500+ whpBuilt 7M or JZ swap (1JZ/2JZ) for 500+ whp.~$15,000–35,000 CAD
À vérifier avant de modifier
- 7M-GTE head gaskets fail, which is widely blamed on factory head-bolt torque. ARP studs are the standard fix.
- 7M uses a Karman-vortex airflow meter that limits airflow and tuning; most builds convert to MAP or a standalone ECU.
- Ceramic CT12A turbines on the 1JZ twin version can shed above about 1 bar.
- Rust (rear arches, sunroof drains), tired TEMS dampers, cracked dashboards.
Différences entre versions
- 7M cars use a CT26 single turbo; the 1JZ car uses twin CT12A.
Base
Head gasket and studs done before any boost.
- Puissance (estimation)
- Stock (~230 hp 7M / ~280 PS 1JZ)
- Budget pièces
- ~$2,500–5,000 CAD
Moteur
- ARP head studs + quality head gasket (7M)ARP 203-4202Toyota OEM updated gasketHKS/Cometic MLS
- Timing belt, water pump and oil pump sealAisinGatesToyota OEM
Refroidissement
- Radiator, hoses and fan clutchKoyoMishimoto
Suspension
- Dampers (replacing TEMS) and bushingsKYBBilsteinTein
Ordre des travaux
- Compression test; if the gasket is original, plan the head job straight away.
- Machine the head flat and fit studs with a quality gasket.
- Timing belt and all fluids, then refresh the vacuum lines.
Rue
Exhaust, boost control and mild boost.
- Puissance (estimation)
- ~260–300 whp (7M) / ~260–300 whp (1JZ, near 1 bar)
- Budget pièces
- ~$2,000–4,500 CAD
Admission et échappement
- 3-inch downpipe and exhaustHKSDriftmotionSR Fab
Électronique et calibration
- Boost controller + fuel cut defenderHKSBlitzGreddy
Refroidissement
- Front-mount intercoolerGreddyMishimotoCXRacing
Freins
- Pads, lines and fluidHawkEBCMotul
Roues et pneus
- Quality 200TW performance tiresYokohamaBridgestoneFalken
Ordre des travaux
- Exhaust and FMIC, then boost controller.
- Fit a wideband AFR gauge before raising boost.
Sportive / Piste
Standalone ECU, fuel and a CT26 hybrid or small single.
- Puissance (estimation)
- ~350–450 whp
- Budget pièces
- ~$6,000–12,000 CAD
Électronique et calibration
- Standalone ECU + MAP conversionHaltechLinkAEMSpeeduino-based
Alimentation
- 550–850 cc injectors + 255–340 lph pumpInjector DynamicsDeatschWerksWalbro
Suralimentation
- CT26 hybrid or bolt-on singleDriftmotion CT26 57-trimGarrett GT3076R
Transmission
- Uprated clutchExedyACTCompetition Clutch
Suspension
- Coilovers and rear LSDTeinBC Racing; CuscoOS Giken
Ordre des travaux
- ECU and fuel first, then turbo.
- Dyno-tune; R154 is fine at this level.
Préparation complète
Built 7M or JZ swap (1JZ/2JZ) for 500+ whp.
- Puissance (estimation)
- 500+ whp
- Budget pièces
- ~$15,000–35,000 CAD
Moteur
- Forged pistons/rods or 2JZ-GTE swapCPManleyWiseco
Suralimentation
- Large single turbo kitPrecisionGarrettBorgWarner
Transmission
- R154 rebuild or V160/CD009 swapDriftmotionCollins
Intérieur
- Cage, seats, harnessesCuscoBrideSparco
Ordre des travaux
- Decide between a built 7M and a JZ swap; a swap is often cheaper per horsepower.
- Upgrade the axles, driveshaft and diff to match.
Les chiffres de puissance et de budget sont des estimations (pièces seulement, en $ CA), pas des garanties : le carburant, la calibration, le climat et le choix des pièces changent tout. Les marques sont des exemples, pas des commandites. Retirer ou vider les catalyseurs, ou désactiver les systèmes antipollution, est illégal sur les voitures de route au Canada et aux États-Unis; les pièces marquées « hors route / piste seulement » sont réservées aux véhicules de compétition.